Guides

What to know before you post a module

A few short explainers we get asked about most.

Diagnosing the fault

What your airbag warning light actually means

A steady airbag/SRS light usually means the system has logged a fault and disabled itself for safety — it isn't always because the airbag has deployed. Common causes include a deployed airbag or pretensioner after a crash, a damaged connector or wiring loom, a low battery voltage during a jump-start, or a module that's simply reached end of life.

A proper diagnostic reads the exact fault code stored in the module rather than guessing from the light alone, which is why we always test before quoting a fix.

Before you sell or scrap

Crash data clearing, explained

Modern airbag modules store an event data recorder (EDR) log — speed, braking and impact data from the moments around a crash. If a vehicle has been in an accident and is being repaired, resold or re-registered, that stored data is often cleared as part of putting it back on the road.

This is a separate step from an airbag reset and is usually done at the same time when both are needed.

Motorhomes

Ducato, Relay and Boxer base units explained

Most UK motorhomes are built on one of three near-identical van chassis: the Fiat Ducato, Citroën Relay or Peugeot Boxer. The airbag and SRS electronics live on the base vehicle, not the habitation conversion, so a base-unit reset is handled the same way as any van — it's the fault-finding around the conversion wiring that takes a bit more care.

Packaging

How to remove and post your module safely

Disconnect the battery before removing any airbag component. Most modules sit under the centre console or dash and are held by two or three bolts — if you're not confident removing it yourself, a local garage can usually do this in a few minutes.

Once it's out, see our posting & packaging steps for how to box it up.